Freeradius server can not see any request from clients.

[Owen DeLong]

Sounds like you may be running iptables or other similar filter software
on your server which is blocking the packet from reaching RADIUS.

Owen

On Oct 26, 2006, at 4:38 AM, richard Bai wrote:

>
>
> Hi, everyone,
>
> I face a very strange problem right now when I configure a  
> freeradius server with PEAP + LDAP.
>
> I can start the radius in debug mode properly. I get following lines:
> Listening on authentication *:1812
> Listening on accounting *:1813
> Ready to process requests.
>
> Then I did test by using " radtest username password localhost 0  
> sharedsecret"
> And the radius server replied with Access-Accept message. So, I  
> think the serve works just fine.
>
> But when I tested by using "radtest username password IP of server  
> 0 sharedsecret" from a client conneted to the server through a hub,  
> I can not get anything back.
> I even did not see any Access-Request information in debug mode on  
> the radius server. It looks like the radius doesn't receive anything.
> However, I sniffered the interface via Ethereal and used " tcpdump - 
> v port 1812 " in the server, I do see the Access-Request packet  
> received by the interface on the server,
> I confirmed that the 1812 port is open.
>
> Please give me some idea. Any advices or solution is welcome.
>
> Thank you very much!
>
>
>
> Best Regards
> Richard
> -
> List info/subscribe/unsubscribe? See http://www.freeradius.org/list/ 
> users.html