Why is radiusd command not found?
- To: freeradius-users@lists.freeradius.org
- Subject: Why is radiusd command not found?
- From: Chad Best <chadabst-1@yahoo.com>
- Date: Sat, 28 Oct 2006 09:29:11 -0700 (PDT)
- Domainkey-signature: a=rsa-sha1; q=dns; c=nofws; s=s1024; d=yahoo.com; h=Message-ID:Received:X-RocketYMMF:Date:From:Reply-To:Subject:To:MIME-Version:Content-Type:Content-Transfer-Encoding; b=B4Qosb+CtwwSmlee0FJVrKCrbrY7Qmcb/F8vR1RXHwweGEI45eHUhuGfYm6O/0uL1xb0gbPIIMtH149YtJtla8sAf1EQcoL88Uw1DfEXsMFymG7kO/DcnnVBO8xUveGceKaucsJ57YDr4SjsST4G6edRWf6BPcatJF7oFK48Igw= ;
- Reply-to: chadabst-1@yahoo.com, FreeRadius users mailing list <freeradius-users@lists.freeradius.org>
This is a total newbie question, but I can figure out the answer to it so I decided to post here. I have installed Freeradius-1.0.0(little behind the times, I know).
After I finished configuring the radiusd.conf, eap.conf, and users files, I tried to start FreeRadius in debug mode. However, when I type "radiusd -X", I get command not found. What did I do wrong? When I installed the program, I just ran ./configure, make, make install so it should have installed properly.
Any help would be greatly appreciated.
This archive was generated by a fusion of
Pipermail (Mailman edition) and
MHonArc.