Using Run-time variables in SQL radreply table

[Alex D.]

>    Hmm... I just checked v2.  The expansion of the attributes in SQL reply table was added before 2.1.8 was released.
>
>    Post the relevant debug output to show what's going on.
>
Wed Dec 20 22:10:09 2017 - User HSI/DEU.MYID.47110815
         Packet-Type = Access-Accept
         ERX-CoS-Shaping-Pmt-Type == "T02 
%{request:Actual-Data-Rate-Downstream}"
         ERX-Virtual-Router-Name = "VRF-HSI-CGN"

mysql> select * from radreply;
+----+-------------------------+--------------------------+----+--------------------------------------------+
| id | username                | attribute                | op | 
value                                      |
+----+-------------------------+--------------------------+----+--------------------------------------------+
|  1 | HSI/DEU.MYID.47110815   | ERX-CoS-Shaping-Pmt-Type | == | T02 
%{request:Actual-Data-Rate-Downstream} |
|  2 | HSI/DEU.MYID.47110815   | ERX-Virtual-Router-Name  | == | 
VRF_HSI_CGN                                |
+----+-------------------------+--------------------------+----+--------------------------------------------+

Is this enough information or should i start radiusd in debug mode 
(radiusd -X) ?

Regards,
Alex