EAP Submodule failed. PAM module issue.

[HORMAZABAL PI�ONES BARBARA FRANCISCA]

>That's small enough that it should be trivial to port it to v3.
Sorry if it's trivial but how can I do this?

>You didn't run "configure" before running "make".  The documentation says
to do this.
I did run configure and then make and make install. I was reading the
documentation while doing this. However a different error appeared today
when doing the process again:

eap_tls.c:132:28: error: dereferencing pointer to incomplete type 'SSL
{aka struct ssl_st}'
            tls_session->ssl->session);
                            ^~
Makefile:25: recipe for target 'eap_tls.lo' failed
make[7]: *** [eap_tls.lo] Error 1
make[7]: Leaving directory '/opt/freeradius_2_2_10/src/modules/rlm_eap/libeap'
Makefile:54: recipe for target 'libeap' failed
make[6]: *** [libeap] Error 2
make[6]: Leaving directory '/opt/freeradius_2_2_10/src/modules/rlm_eap'
Makefile:37: recipe for target 'rlm_eap' failed
make[5]: *** [rlm_eap] Error 2
make[5]: Leaving directory '/opt/freeradius_2_2_10/src/modules'
Makefile:12: recipe for target 'all' failed
make[4]: *** [all] Error 2
make[4]: Leaving directory '/opt/freeradius_2_2_10/src/modules'
Makefile:39: recipe for target 'modules' failed
make[3]: *** [modules] Error 2
make[3]: Leaving directory '/opt/freeradius_2_2_10'


El mié., 16 sept. 2020 a las 23:45, Alan DeKok (<aland at deployingradius.com>)
escribió:

> On Sep 16, 2020, at 10:30 PM, HORMAZABAL PI�ONES BARBARA FRANCISCA <
> bhp001 at alumnos.ucn.cl> wrote:
> >
> >> So... which modules are those?  It would help to say what they are.
> >
> > The modules tried were the PAM-IMAP
> > https://github.com/wdoekes/pam-imap
>
>   That isn't a FreeRADIUS module.
>
> > and rlm_gauth. They are both third party.
> > https://github.com/portellaa/rlm_gauth
>
>   Thats small enough that it should be trivial to port it to v3.
>
> >> "i did stuff and an error happened".
> >
> >> Please read the docs for how to ask GOOD questions:
> >
> > When trying to execute the "make" command and "make install" in
> freeradius
> > 2.2.10 this is the output given:
> >
> > Make.inc:116: *** Building FREERADIUS requires libtool. Stop.
> >
> > Even though libtool is already installed.
>
>   You didn't run "configure" before running "make".  The documentation
> says to do this.
>
>   Alan DeKok.
>
>
> -
> List info/subscribe/unsubscribe? See
> http://www.freeradius.org/list/users.html