This is a total newbie question, but I can figure out the answer to it so I decided to post here.  I have installed Freeradius-1.0.0(little behind the times, I know).<br> <br> After I finished configuring the radiusd.conf, eap.conf, and users files, I tried to start FreeRadius in debug mode.  However, when I type "radiusd -X", I get command not found.  What did I do wrong?  When I installed the program, I just ran ./configure, make, make install so it should have installed properly.<br> <br> Any help would be greatly appreciated.<br> <BR><BR><br>