Hi,

I'm trying to do an account-logon to a cisco ISG (aka NAS). I've created a file to carry the attributes.

The file looks like this..

User-Name += "jane"

Service-Type = Outbound-User

cisco-command-code=01

cisco-avpair = "ssg-account-info=S10.174.168.2:294",

Here's the command I sent.

Radclient –x –f /home/admin/coa_file 10.172.168.6:3799 coa testing123

The debug from radclient doesn't show any errors.

It shows Cisco-Command-Code = "01"

Here's the debug from the cisco router.

Nov 6 22:40:03.489: RADIUS/DECODE: Reply-Message fragments, 13, total 13 bytes

Nov 6 22:43:43.542: RADIUS: COA received from id 164 10.194.170.150:43374, CoA Request, len 84

Nov 6 22:43:43.542: RADIUS/ENCODE(00000000):Orig. component type = Invalid

Nov 6 22:43:43.542: RADIUS/ENCODE: Skip encoding 0 length AAA attribute formatted-clid

Nov 6 22:43:43.543: RADIUS(00000000): sending

Nov 6 22:43:43.543: RADIUS(00000000): Send CoA Nack Response to 10.194.170.150:43374 id 164, len 120

Nov 6 22:43:43.543: RADIUS: authenticator 00 37 CB 5E 01 05 D8 08 - 3F 8F EA 3D 09 88 E4 8F

Nov 6 22:43:43.543: RADIUS: User-Name [1] 6 "jane"

Nov 6 22:43:43.543: RADIUS: Service-Type [6] 6 Outbound [5]

Nov 6 22:43:43.543: RADIUS: Vendor, Cisco [26] 29

Nov 6 22:43:43.543: RADIUS: Cisco AVpair [1] 23 "service-type=Outbound"

Nov 6 22:43:43.543: RADIUS: Vendor, Cisco [26] 10

Nov 6 22:43:43.543: RADIUS: ssg-command-code [252] 4

Nov 6 22:43:43.543: RADIUS: 30 31 [Unknown 01]

Nov 6 22:43:43.543: RADIUS: Vendor, Cisco [26] 25

Nov 6 22:43:43.543: RADIUS: ssg-account-info [250] 19 "S10.174.168.2:294"

Nov 6 22:43:43.543: RADIUS: Reply-Message [18] 18

Nov 6 22:43:43.543: RADIUS: 4E 6F 20 76 61 6C 69 64 20 53 65 73 73 69 6F 6E [ No valid Session]

Nov 6 22:43:43.543: RADIUS: Dynamic-Author-Error[101] 6 Unsupported Service [405]

As you can see it's translating the command code from decimal to hex. How do I specify the command code to be hex? (I've tried 0x01 but again it converts the ascii to hex)

Also, is there documentation that explains the syntax to be used in the attribute file?

Thanks,

Steve