Thanks very much for your answers. In our eap section, we had the following :

 

     copy_request_to_tunnel = no

     use_tunneled_reply = no

 

Since we change these to :

 

    copy_request_to_tunnel = yes    

    use_tunneled_reply = yes

 

The Access-Accept message send VLAN attributes as below :

 

Sending Access-Accept of id 43 to 192.168.100.5 port 5001
        Framed-Protocol = PPP
        Framed-Compression = Van-Jacobson-TCP-IP
        Tunnel-Private-Group-Id:0 = "2"
        Tunnel-Medium-Type:0 = IEEE-802
        Tunnel-Type:0 = VLAN
        User-Name = "toto"
        MS-MPPE-Recv-Key = 0x69f0f1c436ccbe11df23099070ca2c3ceb6116c3246344a8d2c78c96a68fa146
        MS-MPPE-Send-Key = 0x6aad292ef955ae61e910e51a9ae7d2b903f5e123c48dc4cc0e12f713490d2aa3
        EAP-Message = 0x030b0004
        Message-Authenticator = 0x00000000000000000000000000000000
Mon Jun 22 16:08:39 2009 : Debug: Finished request 10.
Mon Jun 22 16:08:39 2009 : Debug: Going to the next request
Mon Jun 22 16:08:39 2009 : Debug: Waking up in 4.0 seconds.

  Unfortunatly, the switch still not switching the port from VLAN 1 to VLAN 2. Maybe

 

there is other misconfigurations on our switch or another settings in radius configurations ?

 

Any ideas to help please!

 

Best regards.