@Hi Alan,

thank you for you answer. Is it possible to block second packages from NAS (that I would not get thous entries in my sqltables)?

p.s.: I do not get any information about this issue on freeswitch maling list...

 71.449050 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Accounting-Request(4) (id=235, l=265)
 71.517347 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Accounting-Response(5) (id=235, l=20)
 73.536126 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Access-Request(1) (id=236, l=210)
 73.567412 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Access-Accept(2) (id=236, l=20)
 73.572794 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Accounting-Request(4) (id=237, l=321)
 73.574156 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Accounting-Response(5) (id=237, l=20)
 83.482760 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Accounting-Request(4) (id=238, l=401)
 83.485670 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Accounting-Response(5) (id=238, l=20)
 83.514594 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Accounting-Request(4) (id=239, l=402)
 83.516404 xxx.xxx.xxx.xxx -> xxx.xxx.xxx.xxx RADIUS Accounting-Response(5) (id=239, l=20)

Regards,
Miha


On 11/9/2011 5:37 PM, Alan DeKok wrote: 
Miha Zoubek wrote:

our freeradius is working with our softswitch perfect. All my columns in
radacct are populating.

  That's good.


Now I have set freeswitch and I also got it work with freeradius. This
are two different softswitchs and I would like that bouth will populate
same base. Problem appears as freeswitch is sending different
attributes, so I make differences in
dialup.conf (than the other softswitch will not populate right radacct
table).

  This is why the SQL queries are editable.  You can edit them to say
"use attribute X, if it doesn't exist, use attribute Y".  See "man
unlang" for the syntax.


Can I populate same base? But how to configure dialup.conf than?
How can I set up in on radius to different base with to different
dialup.conf (I must edit this file due to different attribute
representation).

  Edit dialup.conf.


Below you will find freeswitch attributes:

  Ok... which freeswitch attributes do you want to use?  Which SQL
column do they map to?

  Write that down.  Then, edit the SQL queries as described above.


P.s.: I am getting all inputs in radacct table duplicate. Can you help
me out how can I deal with this issue?

  Your NAS is sending duplicate accounting packets.  That's really how
RADIUS works.  You will need to figure out why the entries are duplicate
(they're probably *not* duplicate), and figure out what fields make up
the "same" session.

  Alan DeKok.
-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html