| Hi, Whenever i use radiusd -X i get the following : This is a part of radiusd -X Sending Access-Challenge of id 8 to 127.0.0.1 port 10004 Tunnel-Type:0 = VLAN Tunnel-Medium-Type:0 = IEEE-802 Tunnel-Private-Group-Id:0 = "2" Symbol-User-Group = "moto" Symbol-Downlink-Limit-Kbps = 0 Symbol-Uplink-Limit-Kbps = 0 EAP-Message = 0x010200061920 Message-Authenticator = 0x00000000000000000000000000000000 State = 0x89c2dbc689c0c2620c47c6a69e0623a2 Finished request 0. Going to the next request Waking up in 4.9 seconds. rad_recv: Access-Request packet from host 127.0.0.1 port 10004, id=9, length=306 User-Name = "kach" Called-Station-Id = "00-15-70-23-F5-34:xtest" Calling-Station-Id = "00-15-70-37-8D-05" NAS-Port = 1 NAS-Port-Type = Wireless-802.11 Framed-MTU = 1400 Service-Type = Framed-User NAS-IP-Address = 127.0.0.1 NAS-Identifier = "RFS4000" Symbol-Wlan-Index = "xtest" Symbol-Attr-4 = "1" NAS-Port-Id = "WLAN1" Connect-Info = "CONNECT 54Mbps 802.11a" State = 0x89c2dbc689c0c2620c47c6a69e0623a2 and etc etc... i did not understand the "waking up in 4.9 sec" ?? Why does it wait for.? can we remove this? Thanx & Regards, Kachin |