Well I eventually found and switched to using linelog to log access rejects since I can define my own variables that are logged. Oddly enough freeradius was showing a packet-type of Access-Request for eap authentication failures. Since I was calling linelog only from the post_auth_reject spot I just changed the Access-Request= definition to:
Access-Request = "Rejected access: %{User-Name} SSID: %{NAS-Port-Id}"
and the filename= line to be: ${logdir}/authrejectlog-%Y%m%d.log
(yep I could make a subsection to linelog with those changes but chose not to).

So I am now logging username rejects as well as the SSID they are trying to connect to. Im not sure why people kept telling me to read the spot above the Post-Auth-Type Reject section. Here is a paste of the text above that section.

# Access-Reject packets are sent through the REJECT sub-section of the
        # post-auth section.
     #
        # Add the ldap module name (or instance) if you have set
     # 'edir_account_policy_check = yes' in the ldap module configuration
        #

This section was of no help to why usernames were not getting logged in the detail logs for rejections. From my emails I believe I conveyed that I was reading documentation and doing the best I could on my own without being a mooch. The only reason I can think of such short and erroneous replies is that some people helping on the list are generally annoyed by any questions. That is too bad. A quick reply of "use linelog" would have been helpful. Why not help people?

-Josh

On Mon, Mar 19, 2012 at 9:15 PM, Josh Hiner <josh@remc1.org> wrote:

Alan. Thanks for the reply. One of my previous emails I did put
reply_log in the post auth reject spot. Im also copying the user from
the inner tunnel to the outer tunnel. I am getting reject logs but
without the username. I swear I have read the section above the post
auth reject spot in my default file under sites enabled and I do have
stuff in that section as it clues me to. I must be missing something
though obviously.

Thanks -josh

Sent from my iPhone

On Mar 19, 2012, at 6:32 PM, Alan Buxey <A.L.M.Buxey@lboro.ac.uk> wrote:

> Hi,
>
>> Ok I went back, looked at the config, and used some common sense to figure
>> part of it out. I have it now logging replys for rejects using the
>
>
> ...to remind you what Alan said:
>
>> �Read raddb/sites-available/default. �Look for Post-Auth-Type Reject.
>>
>> �This is documented.
>
>
> in post-auth section
>
>
> Post-Auth-Type REJECT {
> attr_filter.access_reject
> }
>
> put things in that bit
>
> alan
> -
> List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html