assigning a vlan-id after successful authentication

[Seferovic Edvin]

Hi,

I have been trying to do that on HP 2626 ! But the attributes ( according to
RFC 3500 - I think this one is the right one ) are not accepted by 2626 :(
for some bloody reason the Tunnel-Type aren't accepted by the switch. In the
manuals HP writes that Switch expects VID in the RADIUS reply message. Ive
tried this one too - but no good :(

I think maybe someone should ask HP how they expect this to work!

Regards,

Edvin Seferovic

-----Original Message-----
From: freeradius-users-bounces at lists.freeradius.org
[mailto:freeradius-users-bounces at lists.freeradius.org] On Behalf Of Sven
Juergensen
Sent: Samstag, 12. November 2005 04:48
To: freeradius-users at lists.freeradius.org
Subject: assigning a vlan-id after successful authentication

hello people,

how does the above mentioned work? i am
not quite sure where to start. is it
embedded in the 'Reply-Message' or does
it have to do with the tunnel-types?

i'm trying to supply a vlan-id to an
hp2626 with mac-based authentication.

couldn't find this in the faq or
relevant conf-files either - what am
i missing?

thanks alot in advance,

sven
- 
List info/subscribe/unsubscribe? See
http://www.freeradius.org/list/users.html