same attribute for multiple users

[Sergio Del Pino]

Dear Ivan,

Thank you for your prompt reply.
May be I´m not so clever as you think I´m, I've already read the users
file but I couldn't understand where to put the "DEFAULT" and what to
check.
I've tried to put DEFAULT in first place without any check (what
should I check?), after this line I put in the new line the TAB and
the filter attribute I need, and below this the Fall-Through = 1, This
way didn't work.
May be you are kind and can give me an additional help.
Thanks in advance

Best regards,

Sergio

PS: I will use Cleartext-Password instead of User-Password.

On 9/27/07, tnt at kalik.co.yu <tnt at kalik.co.yu> wrote:
> 1. Read instructions in users file.
>
> 2. Don't use User-Password. To find out what should you use - see 1.
>
> 3. Yes, that's what DEFAULT entries are for. To find out how - see 1.
>
> Ivan Kalik
> Kalik Informatika ISP
>
>
> Dana 27/9/2007, "Sergio Del Pino" <sdelp66 at gmail.com> piše:
>
> >Hi, I'm a newbie on freeradius, I need to send the same attribute to
> >multiple users how can I do, I'm using freeradius.net 1.1.7   my users
> >files work this way
> >
> >user1  User-Password == "pwusr1"
> >user2  User-Password == "pwusr2"
> >....
> >usern  User-Password == "pwusrn"
> >
> >
> >the attribute I need to send is
> >       Filter-Id="some_acl0.in" to any user that radius send access-accept
> >
> >I want to know the config sintax in order to avoid this:
> >
> >
> >user1  User-Password == "pwusr1"
> >       Filter-Id="some_acl0.in"
> >user2  User-Password == "pwusr2"
> >       Filter-Id="some_acl0.in"
> >....
> >usern  User-Password == "pwusrn"
> >       Filter-Id="some_acl0.in"
> >
> >May I use the DEFAULT?
> >
> >Thanks in advance,
> >
> >Sergio
> >-
> >List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
> >
> >
>
> -
> List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
>