Proxy to two RADIUS Servers

[Arran Cudbard-Bell]

Use copy-acct-to-home-server, it's what it's there for. Delay is
usually sub second, but it depends on the throttling values you set in
the detail reader server.

On 14/06/2010, Stefan A. <a.freeradius at premit.de> wrote:
> I checked, whether I am able to manually proxy from sites-available/default,
> using unlang.
> It works fine, using the following commands.
>
>
> 	if (request:Acct-Status-Type == "Start" || request:Acct-Status-Type
> == "Stop") {
> 		if (request:Called-Station-Id  == "apn.isp.de") {
> 			update control {
> 				Replicate-To-Realm += "DEST1"
> 			}
> 		}
> 	}
>
>
> But I do not get it to work, if I try to proxy the same packet to two
> servers:
>
> 	if (request:Acct-Status-Type == "Start" || request:Acct-Status-Type
> == "Stop") {
> 		if (request:Called-Station-Id  == "apn.isp.de") {
> 			update control {
> 				Replicate-To-Realm += "DEST1"
> 				Replicate-To-Realm += "DEST2"
> 			}
> 		}
> 	}
>
> I only uses the first 'Replicate-To-Realm' entry DEST1 and does not seem to
> cycle through a list or destination RADIUS Servers...
>
>
> Is this the intended behavior? Should I go for 'copy-acct-to-home-server' ?
> How much delay would this add between writing the file and sending the
> packet to the home server?
>
>
> Thank you
> Stefan
>
>
>
>
> -
> List info/subscribe/unsubscribe? See
> http://www.freeradius.org/list/users.html
>