Problem with Cache and Reject Users

[Rafal Kaminski]

> Rafal Kaminski wrote:
>> I have problem with users which type 2-3 times bad password.
>> 
>> In debug mode i have something like this:
>> 
>> Fri May 27 16:11:01 2011 : Info: [peap]  The users session was previously rejected: returning reject (again.)
>> Fri May 27 16:11:01 2011 : Info: [peap]  *** This means you need to read the PREVIOUS messages in the debug output
>> Fri May 27 16:11:01 2011 : Info: [peap]  *** to find out the reason why the user was rejected.
>> Fri May 27 16:11:01 2011 : Info: [peap]  *** Look for "reject" or "fail".  Those earlier messages will tell you.
>> Fri May 27 16:11:01 2011 : Info: [peap]  *** what went wrong, and how to fix the problem.
>> 
>> All is fine if users put good password and auth. with LDAP. But some times they made some typo :(
>> 
>> I tried read all line in debug mode, how is write here, but I have one question:
>> 
>> - Is there any possible to remove/clean this cache?
> 
>  There is no cache.  That message means you need to READ THE DEBUG OUTPUT.
> 
>  The reason for rejecting the user is IN THE DEBUG OUTPUT.
> 
>> I set in eap.conf - cache enable=on and lifetime = 1 hours, but nothing.
> 
>  Because that does nothing to solve this problem.
> 
>  Alan DeKok.
> -
> List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html

Ok. I read the OUTPUT and nothing :( Two person with good username and good password had REJECT but on this same PC when i put another user it was ok :( This is very confused for me.

Thanks for help.

Best,

Rafal Kaminski