Sending a disconnect message when replying with an access reject.

Matthew Newton mcn4 at
Thu Apr 18 13:35:14 CEST 2013

On Thu, Apr 18, 2013 at 05:52:16PM +1200, Peter Lambrechtsen wrote:
> When I setup the post-auth policy to send a update disconnect it works fine
> if the response is an access accept. But if I update the control to access
> reject the disconnect module gives me a noop.

As a guess:

The Post-Auth-Type REJECT section in the inner-tunnel is never
called. This is fixed in v2.x.x HEAD and master.

Post-Auth-Type REJECT in the outer tunnel is fine.

This might be your problem.

> Or perhaps I am just doing something wrong.

You didn't send output from radiusd -X.


Matthew Newton, Ph.D. <mcn4 at>

Systems Specialist, Infrastructure Services,
I.T. Services, University of Leicester, Leicester LE1 7RH, United Kingdom

For IT help contact helpdesk extn. 2253, <ithelp at>

More information about the Freeradius-Users mailing list