Multiple Vlan assigment in Free radius server with Cisco Nexus Switch.

deepak rawat deepakrawat.singh at
Thu Dec 16 16:07:54 CET 2021

Hi Alan,
I could not understand your question, Can you explain bit more.But if you asking how the port config looks then it is currenrly configured as trunk mode where both 1968 and 1969 is attached.
cisco-3548-x# show running-config interface ethernet 1/11interface Ethernet1/11  switchport mode trunk  dot1x pae authenticator  dot1x port-control auto  dot1x re-authentication  dot1x host-mode multi-host  switchport trunk allowed vlan 1968-1969  duplex full
cisco-3548-x# show interface ethernet 1/11 switchportName: Ethernet1/11  Switchport: Enabled  Switchport Monitor: Not enabled  Switchport Isolated : Not enabled  Switchport Block Multicast: Not enabled  Switchport Block Unicast: Not enabled  Mac learning: Enabled  Operational Mode: trunk  Access Mode VLAN: 1968 (youlab-10_67_178)  Trunking Native Mode VLAN: 1 (default)  Trunking VLANs Allowed: 1968-1969  Voice VLAN: none  Extended Trust State : not trusted [COS = 0]  Administrative private-vlan primary host-association: none  Administrative private-vlan secondary host-association: none  Administrative private-vlan primary mapping: none  Administrative private-vlan secondary mapping: none  Administrative private-vlan trunk native VLAN: none  Administrative private-vlan trunk encapsulation: dot1q  Administrative private-vlan trunk normal VLANs: none  Administrative private-vlan trunk private VLANs: none  Operational private-vlan: none

Regards,Deepak Rawat 

    On Thursday, December 16, 2021, 01:11:20 PM GMT+1, Alan Buxey <alan.buxey at> wrote:  

There is a mix here  of whether the port is in access mode with a vlan
assigned (usual dot1x activity) , or in trunk mode with multiple vlans

List info/subscribe/unsubscribe? See

More information about the Freeradius-Users mailing list