Using variables in unlang conditions

[Rahman Duran]

Ok, I did what you suggested and defined variables just before "modules {"
but it still does not work, same error.
////////////
######################################################################
#
#  SNMP notifications.  Uncomment the following line to enable
#  snmptraps.  Note that you MUST also configure the full path
#  to the "snmptrap" command in the "trigger.conf" file.
#
#$INCLUDE trigger.conf


#### VARIABLES  #############################
etu_aruba_wlc_rektorluk = 10.10.243.0/24
etu_aruba_wlc_ogrenci_merkezi = 10.10.244.0/24
etu_ssid_eduroam = "eduroam"


# MODULE CONFIGURATION
#
#  The names and configuration of each module is located in this section.
#
#  After the modules are defined here, they may be referred to by name,
#  in other sections of this configuration file.
#
modules {
/////////////////////////

/etc/freeradius/3.0/sites-enabled/default[40]: ((&Packet-Src-IP-Address <
${etu_aruba_wlc_rektorluk})       && (&NAS-Port-Type == "Wireless-80...
/etc/freeradius/3.0/sites-enabled/default[40]:                            ^
Failed to parse value for attribute

Rahman Duran

Message: 2
Date: Fri, 25 Feb 2022 09:55:25 -0500
From: Alan DeKok <aland at deployingradius.com>
To: FreeRadius users mailing list
        <freeradius-users at lists.freeradius.org>
Subject: Re: Using variables in unlang conditions
Message-ID: <C473A2CB-1BB9-4EF8-90DA-36987FD19B90 at deployingradius.com>
Content-Type: text/plain;       charset=us-ascii

On Feb 25, 2022, at 8:28 AM, Rahman Duran <rahman.duran at erzurum.edu.tr>
wrote:
>
> I put it in the authorize section of the default virtual server

  Well, you can't just randomly add things to the "authorize" section.  It
won't work.  The configuration file syntax is documented.

> , just
> before if conditions. So this file is not considered a "configuration
file"
> :) I just put definitions to the end of the radiusd.conf file, try to
start
> in debug mode with freeradius -X, getting the same error:
>
> ((&Packet-Src-IP-Address < ${etu_aruba_wlc_rektorluk})   ^ Failed to parse
> value for attribute
>
> bottom of radiusd.conf
> #### VARIABLES  #############################
> etu_aruba_wlc_rektorluk = 10.10.243.0/24
> etu_aruba_wlc_ogrenci_merkezi = 10.10.244.0/24

  OK, after some looking at it, you should put those in "radiusd.conf",
just before the "modules {" line.  It should then work.

  Alan DeKok.