hi developers! i had a closer look at RADIUS-LDAPv3.schema (rev.1.9.6.1) and compared it with rfc2865 and there seem to be some "inconsistencies": some attributes which may contain zero or more values according to rfc2865 (http://rfc.net/rfc2865.html) are defined as SINGLE-VALUE in the schema file. as far as i understand the rfc the following values (the numbers in brackets refer to the section nr. and page) may contain more values: Filter-Id <-> radiusFilterId (5.11, p.36) Framed-AppleTalk-Network <-> radiusFramedAppleTalkNetwork (5.38, p.58) Framed-Compresion <-> radiusFramedCompression (5.13, p.37) Login-IP-Host <-> radiusLoginIPHost (5.15, p.38) the attribute NAS-IP-Address (radiusNASIpAddress) is described (in rfc) to be allowed to be present zero or one time (see 5.4, p.29, and 5.44: table of attributes, p.63), but is not defined as SINGLE-VALUE in the schema file. i am not using these values right now so i don't know if this differences can cause problems, i just came across this by testing nicolas' patch for bug 261 some time ago and finally had some time and mood to read the rfc. of course i also do not know if these differences are intended, i am just wondering about them! ;-) with best regards, markus -- Markus Krause email: krause@biochem.mpg.de Computing Center Tel.: 089 - 89 40 85 99 Group Lottspeich / Proteomics Fax.: 089 - 89 40 85 98 --------------------------------------------------------------------- This message was sent using https://webmail.biochem.mpg.de If you encounter any problems please report to rz-linux@biochem.mpg.de