Hi, I want to use `files' as the auth method on radius 2.1.3. I added one user to the users file in /etc: "{1}0000001001c2@test.com" Service-Type == Framed-User Framed-IP-Address=30.30.30.1, Framed-MTU=1500, Auth-Type=Accept DEFAULT Service-Type == Framed-User Framed-MTU=1500, Session-Timeout=36000, Termination-Action=Radius-Request, Service-Type=Framed-User when i try tu authenticate this user i get the following error: No authenticate method (Auth-Type) configuration found for the request: Rejecting the user Failed to authenticate the user. I attach the whole debug info: rad_recv: Access-Request packet from host 192.168.0.104 port 49910, id=0, length=141 User-Name = "{1}0000001001c2@test.com" Service-Type = Framed-User Framed-MTU = 1500 Calling-Station-Id = "00-09-02-10-01-C2" NAS-Port-Type = Ethernet NAS-Port = 0 NAS-Port-Id = "ABC" NAS-IP-Address = 192.168.0.104 Event-Timestamp = "Jan 26 2009 09:16:36 EET" Message-Authenticator = 0x2c7e083eefb7491d0e0a102f16edc446 +- entering group authorize {...} ++[preprocess] returns ok ++[chap] returns noop ++[mschap] returns noop [suffix] Looking up realm "test.com" for User-Name = "{1}0000001001c2@test.com" [suffix] No such realm "test.com" ++[suffix] returns noop [eap] No EAP-Message, not doing EAP ++[eap] returns noop ++[unix] returns notfound [files] users: Matched entry {1}0000001001c2@test.com at line 1 ++[files] returns ok ++[expiration] returns noop ++[logintime] returns noop [pap] WARNING! No "known good" password found for the user. Authentication may fail because of this. ++[pap] returns noop No authenticate method (Auth-Type) configuration found for the request: Rejecting the user Failed to authenticate the user. Using Post-Auth-Type Reject +- entering group REJECT {...} [attr_filter.access_reject] expand: %{User-Name} -> {1}0000001001c2@test.com attr_filter: Matched entry DEFAULT at line 11 ++[attr_filter.access_reject] returns updated Delaying reject of request 0 for 1 seconds Going to the next request Waking up in 0.9 seconds. Any hints? Thx a lot.