Hi All, I get this error when running freeradius in debug mode: (6) Found Auth-Type = ntlm_auth (6) Found Auth-Type = Accept (6) ERROR: Warning: Found 2 auth-types on request for user. (6) Auth-Type = Accept, accepting the user Auth-Type Accept is not defined anywhere. Also, when I test against radius using radclient it works fine, but when I test against it using an Azure client, for instance, it mangles the password completely. Installed version is freeradius-3.0.4-8.el7_3.x86_64 Regards, To read FirstRand Bank's Disclaimer for this email click on the following address or copy into your Internet browser: https://www.fnb.co.za/about-fnb/legal-matters/email-disclaimer.html If you are unable to access the Disclaimer, send a blank e-mail to firstrandbankdisclaimer@fnb.co.za and we will send you a copy of the Disclaimer.
On Tue, Jul 04, 2017 at 09:39:45AM +0000, Cooper, Tom wrote:
I get this error when running freeradius in debug mode:
(6) Found Auth-Type = ntlm_auth (6) Found Auth-Type = Accept
(6) ERROR: Warning: Found 2 auth-types on request for user. (6) Auth-Type = Accept, accepting the user
Auth-Type Accept is not defined anywhere.
It must be. What does the full debug output look like? If in doubt you can always put debug statements in the flow to show the content of the control attribute list to see at what point they are being added.
Also, when I test against radius using radclient it works fine, but when I test against it using an Azure client, for instance, it mangles the password completely.
Make sure the shared secret is correct and nothing network-wise is screwing the packets up. -- Matthew
participants (2)
-
Cooper, Tom -
Matthew Newton