Hi, Alan In a previous email, I asked you if Freeradius supports IPv6 authentications and you response to me that CVS version does.
How and where did I configure the IPv6 attributes referred in RFC 3162 to RADIUS distribute them to Authenticated users?
You use the IPv6 attributes from the dictionary, just like you use IPv4 attributes from the dictionary.
Where I can get some documentation about this configuration?
Version 1.0.5 does not listen on IPv6 addresses, so you can't use IPv6 clients, either.
If I can't use IPv6 clients, how I can execute an IPv6 authentication? Did CVS version listening IPv6 addresses?
Alan DeKok.
Thanks in advance, Paulo Ferreira
Paulo Alexandre Caceres Ferreira <caceres@alumni.ipt.pt> wrote:
In a previous email, I asked you if Freeradius supports IPv6 authentications and you response to me that CVS version does.
Yes... so?
You use the IPv6 attributes from the dictionary, just like you use IPv4 attributes from the dictionary.
Where I can get some documentation about this configuration?
Read your NAS documentation on what IPv6 attributes it takes.
Version 1.0.5 does not listen on IPv6 addresses, so you can't use IPv6 clients, either.
If I can't use IPv6 clients, how I can execute an IPv6 authentication?
Is it really that hard to figure out?
Did CVS version listening IPv6 addresses?
Uh... why are you asking this again? Do you think the answer has changed? Alan DeKok.
participants (2)
-
Alan DeKok -
Paulo Alexandre Caceres Ferreira