I apologize. I saw it said updated tutorial for freeradius 2.x at the top of the page and failed to notice the link. never-mind :) On 02/16/2011 01:29 PM, Sallee, Stephen (Jake) wrote:

If you are using ver 1.3.0 then the article is for you ... and you should REALLY think about upgrading, otherwise use Alan's instructions @ http://deployingradius.com/

Jake Sallee

Godfather Of Bandwidth

Network Engineer

Fone: 254-295-4658

Phax: 254-295-4221

*From:* freeradius-users-bounces+jake.sallee=umhb.edu@lists.freeradius.org [mailto:freeradius-users-bounces+jake.sallee=umhb.edu@lists.freeradius.org] *On Behalf Of *Raymond Norton *Sent:* Wednesday, February 16, 2011 12:04 PM *To:* FreeRadius users mailing list *Subject:* wiki question

I am working through the following wiki:

http://wiki.freeradius.org/FreeRADIUS_Active_Directory_Integration_HOWTO#Set...

I'm good till I get to this area:

Configuration of radiusd.conf

Open this file and proceed to the section:

# Microsoft CHAP authentication

Make sure that the following lines are uncommented and that the value is the same as indicated here.

authtype = MS-CHAP with_ntdomain_hack = yes, etc..........................

I don't have any of this info in radiusd.conf, so do I add all of it, or is this info contained elsewhere?

Raymond

-- This message has been scanned for viruses and dangerous content by *MailScanner* <http://www.mailscanner.info/>, and is believed to be clean.

- List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html

Raymond Norton wrote:

I get an empty page for this link:

http://deployingradius.com/documents/configuration/active_directory.html

Which browser? The page has been up and active for years. Alan DeKok.