Hi the list I'm sure this is NAS question, not Freeradius' question. But perhaps somebody on the list had experienced this issue. Here is my problem. I setup : - A Freeradius configuration EAP/PEAP with user credentials stored in LDAP directory. - A NAS zcomax ag3621 wireless access point with VLAN 802.1q support. on this access point, i have one SSID associated by default with guest VLAN 30. meaning if a user failed authentication, he will still connected but on this VLAN with reduced privileges. However radius return the following Access-accept packet to my NAS, Sending Access-Accept of id 81 to 192.168.32.88 port 1032 Tunnel-Private-Group-Id:0 = "60" Tunnel-Medium-Type:0 = IEEE-802 Tunnel-Type:0 = VLAN User-Name = "user1" The access point just put user1 on VLAN 30. My NAS ignore the VLAN ID 60 (Tunnel-Private-Group-Id:0 = "60") contained in the Access-Accept. I try with two different models of Access point (zcomax and cisco) My question: Is there a particular config to do to ask the NAS to consider the VLAN ID contained in the Access-Accept packet ? Thanks for your answers