SPAM-LOW: Re: EAP/TTLS

[Johan Nyman]

Thanks Ivan!


- Some tutorials I have been following required some settings to be changed
in all those files.

- But probably for older version of FreeRadius then.

- I will re-try again!


Thanks for help,

Best regards,
Johan Nyman


-----Original Message-----
From:
freeradius-users-bounces+johan=mediavisiongroup.se at lists.freeradius.org
[mailto:freeradius-users-bounces+johan=mediavisiongroup.se at lists.freeradius.
org] On Behalf Of Ivan Kalik
Sent: den 12 april 2008 16:35
To: FreeRadius users mailing list
Subject: SPAM-LOW: Re: EAP/TTLS

Just make entries for the users in users file. Instructions are in the
file.

There is nothing to configure in radiusd.conf or eap.conf. You might want
to read through eap.conf if you are thinking of replacing default
certificates or perhaps to copy request to tunnel and reply out.

Only other thing you *need* to configure is clients.conf.

Ivan Kalik
Kalik Informatika ISP


Dana 12/4/2008, "Johan Nyman" <Johan at mediavisiongroup.se> piše:

>Hello Alan,
>
>
>- I'm going to copy back the default "eap.conf" "radiusd.conf" and "users"
>files, so I can start over again with clean files.
>
>- Some tutorials I have followed are old, compared to the new version that
I
>have 2.0.3.
>
>- Can you give me an example on how I should configure these three files
>"users" "eap.con" "radius.conf".
>
>- The authentication method I am looking for to use is "EAP/TTLS"
>
>- I have all the certificates ready to go.
>
>
>Thanks very much for help!
>
>Best regards,
>Johan Nyman
>
>
>
>
>
>
>-----Original Message-----
>From:
>freeradius-users-bounces+johan=mediavisiongroup.se at lists.freeradius.org
>[mailto:freeradius-users-bounces+johan=mediavisiongroup.se at lists.freeradius
.
>org] On Behalf Of Alan DeKok
>Sent: den 12 april 2008 10:18
>To: FreeRadius users mailing list
>Subject: SPAM-LOW: Re: FW: Hello,
>
>divisionmd wrote:
>> - How do i check if the clients are using PEAP?
>
>  Read the debug log as suggested in the FAQ, README, INSTALL, and daily
>on this list.
>
>> - Dont know if this is the answer to you password question, i have a
>> password in the USERS file and on the client i have entered in the
>> WPA_Supplicant.conf, clear text word.
>>
>> - Then what type of password how do i check that?
>
>  Read the entry you configured in the "users" file?
>
>  Alan DeKok.
>-
>List info/subscribe/unsubscribe? See
>http://www.freeradius.org/list/users.html
>
>-
>List info/subscribe/unsubscribe? See
http://www.freeradius.org/list/users.html
>
>

-
List info/subscribe/unsubscribe? See
http://www.freeradius.org/list/users.html