WIMAX problem

[tnt at kalik.net]

>I downloaded the last stable version via "git".
>I typed the command git clone
>git://git.freeradius.org/freeradius-server.git radiusd. Is that correct?
>
>Then i installed freeradius and run radiusd but the same log of radiusd
>appeared. The log is at the attachment.
>

rad_recv: Access-Request packet from host 192.168.10.3 port 1812, id=2,
length=314
        User-Name = "{am=1}anonymous at wintegra.com"
        EAP-Message =
0x0202007015800000006616030100610100005d030149502abe282b6324c07315e57a95bd7f42dd38d221a592206f35256651f0c31e00003600390038003500160013000a00330032002f0007006600050004006300620061001500120009006500640060001400110008000600030100
        Message-Authenticator = 0xe0ef04d2f20e8b07aeec51fef34cb796
        NAS-IP-Address = 192.168.10.3
        NAS-Port-Type = 27
        Calling-Station-Id = "\000!\000\r\302#"
        Chargeable-User-Identity = ""
        WiMAX-Release = "1.0"
        WiMAX-Accounting-Capabilities = IP-Session-Based
        WiMAX-Hotlining-Capabilities = Not-Supported
        WiMAX-Idle-Mode-Notification-Cap = Supported
        WiMAX-Available-In-Client = 3
        WiMAX-Session-Termination-Capability = Dynamic-Authorization
        WiMAX-GMT-Timezone-offset = 0
        WiMAX-BS-Id = 0x0050c21174a4
        Service-Type = Framed-User
        Framed-MTU = 2000
        State = 0xc8679e10c8658b965d7f92904f2ccae1
..
[wimax] WARNING: WiMAX-MN-NAI was not found in the request or in the
reply.
[wimax] WARNING: We cannot calculate MN-HA keys.
[wimax] WARNING: WiMAX-IP-Technology not found in reply.
[wimax] WARNING: Not calculating MN-HA keys
++[wimax] returns updated
Sending Access-Accept of id 7 to 192.168.10.3 port 1812
        MS-MPPE-Recv-Key =
0x0b807e1db02ccb8eabde63e0d4f7558f80c50fc6c46bf30f0697a8169a279608
        MS-MPPE-Send-Key =
0x52964f865d141e239c4ef6e8528c3b33c0b3db0c78c7eeee565c07563c161c21
        EAP-Message = 0x03070004
        Message-Authenticator = 0x00000000000000000000000000000000
        User-Name = "{am=1}anonymous at wintegra.com"

So the message is correct! You haven't configured these attributes as
per instructions in wimax module.

Ivan Kalik
Kalik Informatika ISP