Aruba-User-Vlan, how to configure RADIUS to send the that aruba VSA to the controller

[Ivan Kalik]

>
> Ok. I set that parameter you comment: use_tunneled_reply = yes and it does
> not sent the VSA in the access-accept which I think that if radius could
> sent this VSA atributed inside an access-accept paquet then the NAS would
> understand it.

That would work, if only you enabled it in the *correct* section!

>
> My configuration of eap.conf:
>
> ttls {

Nice, but ...

...
> [eap] processing type peap
...

... you are not doing EAP-TTLS. Enable same parameter in peap section of
eap.conf.

Ivan Kalik
Kalik Informatika ISP