Aruba-User-Vlan, how to configure RADIUS to send the that aruba VSA to the controller

[aangles]

thank you very much Kalik.

Now it works!! :)


Ivan Kalik wrote:
> 
>>
>> Ok. I set that parameter you comment: use_tunneled_reply = yes and it
>> does
>> not sent the VSA in the access-accept which I think that if radius could
>> sent this VSA atributed inside an access-accept paquet then the NAS would
>> understand it.
> 
> That would work, if only you enabled it in the *correct* section!
> 
>>
>> My configuration of eap.conf:
>>
>> ttls {
> 
> Nice, but ...
> 
> ...
>> [eap] processing type peap
> ...
> 
> ... you are not doing EAP-TTLS. Enable same parameter in peap section of
> eap.conf.
> 
> Ivan Kalik
> Kalik Informatika ISP
> 
> -
> List info/subscribe/unsubscribe? See
> http://www.freeradius.org/list/users.html
> 
> 

-- 
View this message in context: http://www.nabble.com/Aruba-User-Vlan%2C-how-to-configure-RADIUS-to-send-the-that-aruba-VSA-to-the-controller-tp25716490p25750021.html
Sent from the FreeRadius - User mailing list archive at Nabble.com.