Free radius : Increase debug log level

[A.L.M.Buxey at lboro.ac.uk]

Hi,

>    Can we get the procedure for going for an upgrade to 2.2.5 version and if
>    that's supported in RHEL 5.10 ?

just build it the same way as your current version has been built.... the 'make install'
should not touch any present file....but its best practice/safer to ensure you have
a backup copy of your config anyway so eg

cp -R /etc/raddb /etc/raddb.backup

before doing the install

there are MINIMAL differences between the previous versions and if you havent used any special
features it should be a pretty much drop in replacement....however, the general advice is
to note down what configuration change you made to the original and then re-enact those on a FRESH
clean config (ie check your change log/revisions and then do  'mv /etc/raddb /etc/raddb.backup' instead
and then edit the files in the config directory to match your requirements) - in this way you rconfig
files have ALL the new options/docs present so you can start using the newer features rather than
not knowing about them.  for a 2.1.x - 2.2.x this isnt too bad..... the jump to 3.x is quite another thing! ;-)

alan