Hi, Not sure this answers your question but.. I use the following setup for extreme switches.. ############ # Access layer admin NAS-IP-Address == 192.168.0.9, Auth-Type = System Service-Type = Administrative-User ############ Administrative-User = Read/Write Login-User = Read only Best Regards Mats Blomgren B -----Original Message----- From: freeradius-users-bounces+mats.b.blomgren=ericsson.com@lists.freeradius.org [mailto:freeradius-users-bounces+mats.b.blomgren=ericsson.com@lists.freeradius.org] On Behalf Of Wagner Pereira Sent: den 15 april 2010 16:26 To: FreeRadius users mailing list Subject: What nastype for Extreme switch? Hi, all. I installed the AAA model Radius on my Extreme's switch and I am already able to log in into it, but I just enter in this device through the non-privileged mode ( > ). I was taking a look at http://linux.die.net/man/5/clients.conf and it says: ---------------------------- nastype The nastype attribute is used to tell the checkrad.pl script which NAS-specific method it should use when checking simultaneous use. The following values are currently recognized: cisco computone livingston max40xx multitech netserver pathras patton portslave tc usrhiper other ---------------------------- Which of these nastype values I must to use for Extreme devices? Thanks. -- Wagner Pereira PoP-SP/RNP - Ponto de Presença da RNP em São Paulo CCE/USP - Centro de Computação Eletrônica da Universidade de São Paulo http://www.pop-sp.rnp.br Tel. (11) 3091-8901 - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html