If this is already a known issue, forgive me - I did not find anything in the archives or bug database that appeared relevant. I'm trying to upgrade from FreeRADIUS 1.1.2 to 1.1.6 - building from source on Debian Linux (sarge). The build goes without a hitch, but when running the new version and using the existing configuration files I get the following (relevant output from 'radiusd -X'): ... Module: Loaded preprocess preprocess: huntgroups = "/s/freeradius-1.1/etc/raddb/huntgroups" preprocess: hints = "/s/freeradius-1.1/etc/raddb/hints" preprocess: with_ascend_hack = no preprocess: ascend_channels_per_line = 23 preprocess: with_ntdomain_hack = no preprocess: with_specialix_jetstream_hack = no preprocess: with_cisco_vsa_hack = no preprocess: with_alvarion_vsa_hack = no /s/freeradius-1.1/etc/raddb/huntgroups[30]: Parse error (check) for entry snt-console: Unknown value 1-22 for attribute NAS-Port rlm_preprocess: Error reading /s/freeradius-1.1/etc/raddb/huntgroups radiusd.conf[249]: preprocess: Module instantiation failed. radiusd.conf[341] Unknown module "preprocess". radiusd.conf[340] Failed to parse authorize section. The section in the huntgroups file it is choking on is this: snt-console NAS-IP-Address == aaa.bbb.ccc.ddd, NAS-Port == 1-22 If I comment that line out, it also chokes on this entry with a slightly different error ( "=" expected): nci-console NAS-IP-Address == aaa.bbb.ccc.ddd, NAS-Port == 1,25-32 So - did the syntax for huntgroups change or is this a real bug ? This config works fine with 1.1.2 - I have not tried any of the versions between 1.1.2 and 1.1.6 to narrow down the issue. I can send the full debug output if needed but I didn't want to clobber the list unnecessarily. Thanks, Craig