Hi,
With XP SP3 the auth failed, I googled that FR 1.1.0 is not capable to do this, because SP3 is realizing the same 802.1x engine as Vista does. So I upgraded to 2.1.3 and compiled it on OpenSuse 10.1 without errors and the software runs without problems. But the auth still doesn't work. I'am a bit confused about the new inner-tunnel and a few options I'am not aware of from my FR 1.1. setup. Is there somewhere a walk-thru published to make XP SP3 work with FR again?
if you had a working 1.1.0 system then you could upgrade quickly to 1.1.7 - same config etc etc - and then spend 'offline-time' getting your config migrated to work with 2.1.3 (use a test box...or the same box but with FR listening on different ports). migrating from 1.x to 2.x isnt too hard, but its certainly not a quick 'dump old config over' operation....those with migration experience can effect it within hours. alan