Dear Friends, Thanks a lot for your reply to fix the issue with the talloc llib during config step. I run below command to complete the config step and it went successfully. $>./configure --with-talloc-lib-dir=/opt/csw/lib --with-talloc-include-dir=/opt/csw/include/ --prefix=$INSTALL_DIR/RADIUS_STACK I checked the exit status of above command it is 0. After that I run gmake however I am getting below error message. As per the message, I checked the file /src/include/autoconf.sed - the file is not exist in the location. I kindly request you to help me to clear/fix below error message please. Thanks in advance for your help. $>gmake /bin/sh: test: argument expected /bin/sh: s,#[\\t ]*ifdef[\\t ]*" $2 "$,#if "$3 ",g;s,#[\\t ]*ifndef[\\t ]*" $2 "$,#if !"$3 ",g;s,defined(" $2 ")," $3 ",g;"}: not found gmake: *** [src/include/autoconf.sed] Error 1 Usage: grep -hblcnsviw pattern file . . . On Thu, Nov 5, 2015 at 6:45 AM, Fajar A. Nugraha <list@fajar.net> wrote:
On Wed, Nov 4, 2015 at 1:35 PM, srithar jeevadurai < srijeevadurai1@gmail.com
wrote:
Dear Friends,
I am trying to compile freeRadius 3.0.9. on Solaris 10 environment. Initially I have faced the error "configure: error: FreeRADIUS requires libtalloc".
I have installed the libtalloc.so.2 on my server.
did you install libtalloc_dev?
-- Faja - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
-- Regards, Srithar Durairaj Alternate Mail I.D: srijeevadurai1@yahoo.co.in Mobile: +919886251852