On 01/03/2014 01:52 PM, Michael Aldridge wrote:
Having just completely purged and reinstalled freeradius, I cannot get the default configuration to work. Here is the output from a request in debug mode:
rad_recv: Access-Request packet from host 127.0.0.1 port 59114, id=221, length=59 User-Name = "testing" User-Password = "password" NAS-IP-Address = 127.0.1.1 NAS-Port = 0 # Executing section authorize from file /etc/freeradius/sites-enabled/default +- entering group authorize {...} ++[preprocess] returns ok ++[chap] returns noop ++[mschap] returns noop ++[digest] returns noop [suffix] No '@' in User-Name = "testing", looking up realm NULL [suffix] No such realm "NULL" ++[suffix] returns noop [eap] No EAP-Message, not doing EAP ++[eap] returns noop ++[files] returns noop ++[expiration] returns noop ++[logintime] returns noop [pap] WARNING! No "known good" password found for the user. Authentication may fail because of this. ++[pap] returns noop ERROR: No authenticate method (Auth-Type) found for the request: Rejecting the user Failed to authenticate the user. Using Post-Auth-Type Reject # Executing group from file /etc/freeradius/sites-enabled/default +- entering group REJECT {...} [attr_filter.access_reject] expand: %{User-Name} -> testing attr_filter: Matched entry DEFAULT at line 11 ++[attr_filter.access_reject] returns updated Delaying reject of request 0 for 1 seconds Going to the next request Waking up in 0.9 seconds. Sending delayed reject for request 0 Sending Access-Reject of id 221 to 127.0.0.1 port 59114
The user and testing were performed following the guide found on the freeradius wiki here: http://wiki.freeradius.org/guide/Basic-configuration-HOWTO
any help is greatly appreciated!
Try reading what you posted, the answer is there. See the line that says: ERROR: No authenticate method (Auth-Type) found for the request Hmm ... let's see, why wouldn't there be a password for the user "testing"? Maybe because you wiped out the user's file where you put that information? -- John