Hi all, Anybody knows how to configure freeradius to send access list configuration back to a cisco router applied to Dialer 0. Thanks, Jorge Pallares ________________________________ Email disclaimer: The information contained in or attached to this communication may contain confidential or privileged information and is intended for the addressee only. If you are not the intended recipient of this email communication, you are notified that any use, dissemination, distribution or copying of this message or data is prohibited. If you have received this email in error, please notify the sender by return email and permanently delete the document. Any drawing provided with this communication is provided for general information purposes only. No person receiving or using that drawing should rely on it as a complete or accurate representation of the rail assets referred to in it. All written dimensions take precedence over scaled dimension. The drawing has been prepared by, or compiled from information provided by, persons other than VicTrack. To the maximum extent permissible by law, VicTrack takes no responsibility for, and makes no representations in relation to, the completeness, accuracy or quality of any information contained in the drawing. Each user of the drawing releases VicTrack from all and any loss, damage, cost, expense or liability in relation to the use of, or any reliance on, the drawing or the information contained in it. The drawing is provided only for the information of the person or organisation to whom VicTrack provides it. It may not be provided to, or used by, any other person without VicTrack's prior written consent. The views expressed in this message are those of the individual sender, except where the sender specifically states them to be the views of VicTrack. VicTrack does not guarantee that the integrity of this communication has been maintained nor that this communication is free of viruses, interceptions or interference.