up@3.am wrote:
I can tell that ldap failover config is a FAQ by the number of hits I found searching for this, but it seems that many of the config examples are for older versions of FreeRADIUS. In any case, this is what I've tried, but it's not working:
See the FAQ for "it doesn't work".
ldap ldap2{ .... set_auth_type = yes
Thanks for pointing that out...I had just copied and pasted that section from the secondary radius server.
Which will set "Auth-Type := ldap2". That's probably not what you want.
This is what I put in sites-enabled/default AND in sites-enabled/inner-tunnel (it doesn't look right to me, but it's what I found):
authorize { preprocess redundant LDAP{ ldap1 ldap2 }
That looks OK...
Auth-Type LDAP { ldap1 ldap2 }
That doesn't. It goes into the "authenticate" section, and you need add a "redundant" block which wraps the calls to "ldap1" and "ldap2"
That did the trick...I changed it to this: #Auth-Type LDAP { redundant LDAP{ ldap1 ldap2 } I wasn't sure if you used both "Auth-Type" AND "redundant", but apparently you only need the latter. Thanks once again, Alan!