Vendor specific attributes in Access-Accept message

Hello i am trying to send below two Cisco Vendor Specific Attributess in every access-accept message. How do i do this? Cisco­AVPair := "sub­qos-policy-in=S99_IN_POLICING_5Mbps" Cisco­AVPair := "sub­qos-policy-out=S99_OUT_POLICING_5Mbps" I've read that i need to add the VSAs to the dictionary but i cant figure out how to do this. Also how do i set the rule that in every access-accept the VSA are sent? I tried adding them to the user file luck this but no luck… - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - - - - - - - - - - - testing Cleartext-Password := "password" Cisco­AVPair := "sub­qos-policy-in=S99_IN_POLICING_5Mbps" Cisco­AVPair := "sub­qos-policy-out=S99_OUT_POLICING_5Mbps" - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - - - - - - - - - - - - - - - - - - - - - - This is what I'm getting from radiusd -X output - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - reading pairlist file /etc/raddb/mods-config/files/authorize /etc/raddb/mods-config/files/authorize[90]: Parse error (reply) for entry testing: Expecting operator Failed reading /etc/raddb/mods-config/files/authorize /etc/raddb/mods-enabled/files[9]: Instantiation failed for module "files" - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - If someone could also point me to a good guide or wiki on adding and testing VSAs that would be great Best regards, ________________________________ Note: All emails sent from Safaricom Limited are subject to Safaricom’s Email Terms & Conditions. Please click here to read the policy. http://www.safaricom.co.ke/images/Downloads/Terms_and_Conditions/safaricom_e...