I have followed several tutorials for setting up Active Directory with FreeRadius. When I run the ntlm_auth from the command line I get a success message however when I run the radtest with the username and password I get a Access-Reject. I am using FreeRadius 1.8 and I have included the message I get from radiusd -X. Any input would be greatly appreciated. rad_recv: Access-Request packet from host 10.1.174.126:3421, id=26, length=49 User-Name = "testuser" User-Password = "testpassword" Processing the authorize section of radiusd.conf modcall: entering group authorize for request 3 modcall[authorize]: module "preprocess" returns ok for request 3 modcall[authorize]: module "chap" returns noop for request 3 modcall[authorize]: module "mschap" returns noop for request 3 rlm_realm: No '@' in User-Name = "jmcsparin", looking up realm NULL rlm_realm: No such realm "NULL" modcall[authorize]: module "suffix" returns noop for request 3 rlm_eap: No EAP-Message, not doing EAP modcall[authorize]: module "eap" returns noop for request 3 modcall[authorize]: module "files" returns notfound for request 3 rlm_pap: WARNING! No "known good" password found for the user. Authentication may fail because of this. modcall[authorize]: module "pap" returns noop for request 3 modcall: leaving group authorize (returns ok) for request 3 auth: No authenticate method (Auth-Type) configuration found for the request: Rejecting the user auth: Failed to validate the user. Joseph R. McSparin Network Administrator Hill Country Memorial Hospital 830 990 6638 phone 830 990 6623 fax jmcsparin@hillcountrymemorial.org -- This email message and any attachments are for the sole use of the intended recipient(s) and contain confidential and/or privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message and any attachments.