Thanks for the quick reply. I figured i missed something in the freeradius configuration to enforce these attributes somehow. Don't have a very big knowledge of freeradius. So thanks for the confirmation that i should be looking at the switch rather than the freeradius (which I have been doing mostly). Kind regards Martijn Craeghs On 12 May 2015 at 13:46, Alan DeKok <aland@deployingradius.com> wrote:
On May 12, 2015, at 7:11 AM, Martijn Craeghs <martijncr@msn.com> wrote:
As far as authentication goes it works. My user get's authenticated and recieves an Access-Accept message in this form.
That's good. All of the correct VLAN attributes are there.
Sending Access-Accept of id 12 to xxx.xxx.xxx.xxx port 6103 Tunnel-Private-Group-Id:0 = "vlan_name"
This should be the string representing the VLAN number... i.e. "50".
I've added the tunnel attributes to my LDAP directory and like the previous freeradius debug message show it's stored in the radius package.
Then you've configured FreeRADIUS correctly.
I've ran out of options and forums to look through at this point.
Would be glad if someone could give me a push in the right direction. Not even sure if i should look for the problem on the freeradius side or the switch side.
It's probably the switch. Use the VLAN number, not name, in the FreeRADIUS configuration. That will probably make the switch assign the correct VLAN.
As always, when the packet from FreeRADIUS is correct and it still doesn't work... blame the NAS / AP / switch.
Alan DeKok.
- List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html