OK Thanks for pointing out my Fedora install didn't have "make" installed. This looks much better: <paste> Listening on authentication address * port 1812 Listening on accounting address * port 1813 Listening on command file /var/run/radiusd/radiusd.sock Listening on proxy address * port 1814 Ready to process requests. Thanks again, jw ----- Original Message ---- From: John Williams <jwill911@yahoo.com> To: freeradius-users@lists.freeradius.org Sent: Wednesday, December 31, 2008 4:50:57 PM Subject: newbie new freeradius install fails to start... Hello, Maybe someone can guide me out of this maze. I have a new Fedora 10 install running on Dell intel platform. I installed freeradius.i386 0:2.1.3-1.fc10 package using yum installer. All I did before starting in debug mode was edit clients.conf and users file. I get this error at the end of the config file parse each time I attempt to start "radiusd -X" <paste> /etc/raddb/certs/bootstrap: line 15: make: command not found Exec-Program output: Exec-Program: returned: 127 rlm_eap: Failed to initialize type tls /etc/raddb/eap.conf[17]: Instantiation failed for module "eap" /etc/raddb/sites-enabled/inner-tunnel[223]: Failed to find module "eap". /etc/raddb/sites-enabled/inner-tunnel[176]: Errors parsing authenticate section. } } Errors initializing modules <end paste> If someone could help I'd be really happy. Thanks, jw - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html