Coa problem

7 Nov 2012

      Hello,

I have a problem with originate-coa

I want to send coa to mikrotik to change bandwith

But if I do that I get the folowing error:
(0)    update coa {
ASSERT FAILED evaluate.c[1154]: output_vps
Aborted (core dumped)

I'm using freeradius version 3.0 (I have tried it with radius version 2.1.10, error was slightly different go a segmentation fault)

here is the code within sites-enables/default

update coa {
         User-Name = "%{User-Name}"
         Acct-Session-Id = "%{Acct-Session-Id}"
         NAS-IP-Address = "%{NAS-IP-Address}"
         Framed-IP-Address = "%{Framed-IP-Address}"
         Mikrotik-Rate-Limit = "256K/256K"
}

This is send from accounting {

I put originate-coa in the sites-enabled

and I have made the folowing config:

home_server mikrotik-test-coa {
        type = coa

        #
        #  Note that a home server of type "coa" MUST be a real NAS,
        #  with an ipaddr or ipv6addr.  It CANNOT point to a virtual
        #  server.
        #

        ipaddr = 192.168.8.97
        port = 3799

        #  This secret SHOULD NOT be the same as the shared
        #  secret in a "client" section.
        secret = <same as in clients.conf, because in the NAS it is the same>

        #  CoA specific parameters.  See raddb/proxy.conf for details.
        coa {
                irt = 2
                mrt = 16
                mrc = 5
                mrd = 30
        }
}

server originate-coa.mikrotik {
  pre-proxy {
#        update proxy-request {
#                NAS-IP-Address = 127.0.0.1
#        }
        ok
  }

  #
  # Handle the responses here.
  #

  post-proxy {
        switch "%{proxy-reply:Packet-Type}" {
                case CoA-ACK {
                        ok
                }

                case CoA-NAK {
                        # the NAS didn't like the CoA request
                        ok
                }

                case Disconnect-ACK {
                        ok
                }

                case Disconnect-NAK {
                        # the NAS didn't like the Disconnect request
                        ok
                }

                # Invalid packet type.  This shouldn't happen.
                case {
                     fail
                }
        }

        #
        #  These methods are run when there is NO response
        #  to the request.
        #
        Post-Proxy-Type Fail-CoA {
                ok
        }

        Post-Proxy-Type Fail-Disconnect {
                ok
        }
  }
}

I have tried many many different settings in originate-coa

when I use radclient I can send a coa with succes.

Coa problem

Mixmasterontour PureDJ