Hi: First thanks to the freeRADIUS team - this is one of the most flexibile and powerful AAA available... I've 2 questions: 1. I've set up my clients to authenticate using EAP-TTLS with MSCHAPv2 as the inner authentication protocol. This works fine with the wpa_suppicant with intel 2200b/g as well as the Cisco Aironet 350. I've created my own dictionary file with VSAs that are useful for my NAS once Access-Accept is returned. The 'users' file has the VSAs Attrib = Value listed after each user entry and I do see the attributes being returned correctly on Access-Accept. My question is (please correct me if I am wrong) - I see the VSAs being returned during the intermediate Access-Challenge messages too even before authentication is complete. Is this the normal behavior, is there a way to setup the freeRADIUS server so that the VSAs are only returned on Access-Accept and not during the Access-Challenge. The NAS does ignore the VSAs in any case during the challenge - but would be good if there was a way to limit the message size for the Access-Challenge messages (only if this is valid from RADIUS RFC perspective - if someone could clarify). 2. How can I set users in the 'users' file (an example would be very helpful if someone can send) so that some users are only allowed to authenticate using EAP-TTLS while others are only allowed to use PEAP. Once I create an entry into the users file (and both authentications are EAP types) - the user can authenticate using any eap type - I would like to limit this per user. Is it possible?? Thx. Regards, Mohammed. --------------------------------- New Yahoo! Messenger with Voice. Call regular phones from your PC and save big.