Hi, this is just a little test-setup I've made. I'm using a Netgear WG102 and freeRadius 1.1.7 The server is configured (I hope) to use a password-list (passwd in radiusd-conf) When I try to connect with a correct username and password from the list, this is what i see on the server: rad_recv: Access-Request packet from host 192.168.1.24:1031, id=7, length=164 Message-Authenticator = 0x320609cfc70f95aa5e480e1766fdf1d1 Service-Type = Framed-User User-Name = "isi" Framed-MTU = 1488 Called-Station-Id = "00184DFCC7B8:Gast" Calling-Station-Id = "0019E3D7B020" NAS-Identifier = "wg102" NAS-Port-Type = Wireless-802.11 Connect-Info = "CONNECT 54Mbps 802.11g" EAP-Message = 0x0200000801697369 NAS-IP-Address = 192.168.1.24 NAS-Port = 1 NAS-Port-Id = "STA port # 1" Processing the authorize section of radiusd.conf modcall: entering group authorize for request 0 modcall[authorize]: module "preprocess" returns ok for request 0 modcall[authorize]: module "chap" returns noop for request 0 modcall[authorize]: module "mschap" returns noop for request 0 rlm_realm: No '@' in User-Name = "isi", looking up realm NULL rlm_realm: No such realm "NULL" modcall[authorize]: module "suffix" returns noop for request 0 rlm_passwd: Added User-Password: 'glock' to config_items rlm_passwd: Adding "Auth-Type = accept" modcall[authorize]: module "userlist" returns ok for request 0 modcall[authorize]: module "files" returns notfound for request 0 rlm_pap: Found existing Auth-Type, not changing it. modcall[authorize]: module "pap" returns noop for request 0 modcall: leaving group authorize (returns ok) for request 0 rad_check_password: Found Auth-Type accept rad_check_password: Auth-Type = Accept, accepting the user Sending Access-Accept of id 7 to 192.168.1.24 port 1031 Finished request 0 Going to the next request --- Walking the entire request list --- Waking up in 6 seconds... rad_recv: Access-Accept packet from host 192.168.1.24:1031, id=7, length=20 Authentication reply packet code 2 sent to a non-proxy reply port from client wg102:1031 - ID 7 : IGNORED And then it starts again. Can somebody tell me what is happening here? What am I doing wrong? Thanks a lot Wolfgang Burger