Hi, I am using FreeRADIUS Version 2.1.7, this is the RPM for RHEL made available from (http://people.redhat.com/jdennis/freeradius-rhel-centos) which was linked by the RedHat FAQ on the FreeRadius Wiki (actually I downloaded the .srpm and change the .spec file to include --with-udpfromto in the configure line). Anyway I seem to have an odd issue. I have two home servers configured with the below proxy.conf, the issue is when both server1 and server2 are up load balancing works fine when I take down server 1 it goes into zombie then it is marked dead which is all great (I posted those messages below as well), then when I bring server 1 back online FreeRadius' status_check sees the server up ( I posted that message below as well) however no more Radius requests go to server1 (not unless I take server2 down then I can see server1 starts to receive the requests) but it seems like either there is a bug or I have something mis configured because I would assume once the status_check notices server1 is back online it should start to receive radius requests again.. home_server server1 { type = auth+acct ipaddr = XXX.XXX.XXXX.XXXX port = 1812,1813 secret = secret require_message_authenticator = no response_window = 20 zombie_period = 10 # revive_interval = 120 status_check = request username = username@host.com password = secret check_interval = 5 num_answers_to_alive = 3 } home_server server2 { type = auth+acct ipaddr = XXX.XXX.XXX.XXX port = 1812,1813 secret = secret require_message_authenticator = no response_window = 20 zombie_period = 10 # revive_interval = 120 status_check = request username = username@host.com password = secret check_interval = 5 num_answers_to_alive = 3 } home_server_pool balance { type = load-balance home_server = pcrf01 home_server = pcrf02 } realm DEFAULT { pool = balance nostrip } ------------------ end proxy.conf -------------------- ------ DEAD SERVER -------------------- PROXY: Marking home server XXX.XXX.XXX.XXX port 1812 as zombie (it looks like it is dead). Sending Access-Request of id 222 to XXX.XXX.XXX.XXX port 1812 User-Name := "username@host.com" User-Password := "secret" Service-Type := Authenticate-Only Message-Authenticator := 0x00000000000000000000000000000000 NAS-Identifier := "Status Check. Are you alive?" Waking up in 3.9 seconds. Waking up in 4.3 seconds. ---------- end DEAD SERVER ------------ ------ Server Alive ----------------- rad_recv: Access-Accept packet from host XXX.XXX.XXX.XXX port 1812, id=185, length=20 Waking up in 10.0 seconds. --------- end Server Alive -------------