I've setup freeradius by following the "Using Oracle as a Backend DB for a Radius Server" document at www.ceta.ufm.edu.gt. The server will load the rlm_sql_oracle module and start. It is also communicating with the database properly. However, It will not authenticate users from that database. I get the following messages by watching the output of "radiusd -X" <snip> modcall[authorize]: module "sql" returns ok for request 8 modcall: group authorize returns ok for request 8 rad_check_password: Found Auth-Type System auth: type "System" Processing the authenticate section of radiusd.conf modcall: entering group authenticate for request 8 modcall[authenticate]: module "unix" returns notfound for request 8 modcall: group authenticate returns notfound for request 8 auth: Failed to validate the user. Delaying request 8 for 1 seconds Finished request 8 Going to the next request --- Walking the entire request list --- Waking up in 1 seconds... rad_recv: Access-Request packet from host 10.28.4.10:32770, id=13, length=102 Sending Access-Reject of id 13 to 10.28.4.10:32770 <snip> It will authenticate usernames that exist on the local system. It seems that it is defaulting to checking the password on the system instead of the password stored in the database table. Should I set a specific Auth-Type in the radreply table or is my problem due to misconfiguration of radiusd.conf? Thanks in advance, Sam