If I plugin XP to eth0 (network line), the server will assign an IP address to that computer and immediately able to connect to internet (iptables redirect traffic to eth1).
So you have DHCP working there. No authentication.
then I try to authenticate the wifi client I wonder why the NAS-IP-Address always show 0.0.0.0
You will have to consult NAS documentation about setting IP addresses on that device.
but when I run radtest on terminal server it shows IP address..
# radtest MarsNet 000 localhost 0 testing123
User-Name = MarsNet
User-Password = 000
NAS-IP-Address = 192.168.1.10 ( server IP address)
NAS-Port = 0
#
Ugh. This is also wrong. Localhost should resolve to 127.0.0.1 not server IP address. This is nothing to do with radius. Your network setup is bad. Fix the network so IP addresses resolve properly.
In previous email you were mention about client attribute fail. How to fix it?
Which attribute? Was it State? If it was, than that equipment is unusable. Replace it with equipment that works. Ivan Kalik Kalik Informatika ISP