Hi all the FR receive the accounting request: rad_recv: Accounting-Request packet from host 172.26.0.8 port 1645, id=186, length=399 User-Name = "0873000001" NAS-IP-Address = 0.0.0.0 Service-Type = Dialout-Framed-User Class = 0x436c6173733d333030 Cisco-AVPair = "h323-incoming-conf-id=b97aff16 c99911dd 8125d127 98296413 " h323-conf-id = "h323-conf-id=b97aff16 c99911dd 8125d127 98296413 " h323-setup-time = "h323-setup-time= 4:43:17.000 UTC Mon Dec 15 2008" h323-connect-time = "h323-connect-time= 4:43:21.000 UTC Mon Dec 15 2008" h323-call-type = "h323-call-type=VOIP" Called-Station-Id = "0873000012" Calling-Station-Id = "0873000001" Acct-Status-Type = Start Acct-Session-Id = "b97aff16 c99911dd 8125d127 98296413 " Event-Timestamp = "Dec 15 2008 11:43:21 ICT" NAS-Port-Type = Ethernet then FR should send accounting respond : h323-credit-amount=customer balance at the time of authentication h323-return-code=0(accept)/2(reject) h323-billing-model=2 but FR send: Sending Accounting-Response of id 192 to 172.26.0.8 port 1645 can the FR do that? if yes, where should i edit if i want to send response to NAS i should add the attribute in the attrs.accounting-response : h323-credit-amount=* ANY h323-return-code=* ANY h323-billing-model=* ANY i check the attrs.accounting-reponse: # # Configuration file for the rlm_attr_filter module. # Please see rlm_attr_filter(5) manpage for more information. # # $Id$ # # This configuration file is used to remove almost all of the attributes # From an Accounting-Response message. The RFC's say that an # Accounting-Response packet can contain only a few attributes. # We enforce that here. # DEFAULT Vendor-Specific =* ANY, Message-Authenticator =* ANY, Proxy-State =* ANY, 1 more question: i read the man unlang times but cannot figure out how to use it could you give the example for specific case such as Access Reject/ update the Access Reject/Accept Thanks Ha`