I just follow the steps. Create group, add users to the group. and create Remote Access Policy in IAS(Internet Authenticate Service).Does it in right place??? ,edit policy and apply policy to this group. But freeradius can not get the VLAN information from AD. Thanks. tnt@kalik.co.yu ��� Since you are using AD to store user profile this is an AD, not freeradius question. Create a (vlan) group; add users/groups to the group; create Remote Access Policy; apply policy to this group; edit the policy to include those Tunnel attributes in dial-in profile; do the same for every VLAN. Ivan Kalik Kalik Informatika ISP Dana 2/8/2007, "Hangjun He" pi�e:
Hi, We use peap + AP + fr + AD to authenticate user. Now It can work. But I need to get VLAN from freeradius for different user or group. How should I do?? Please give me some advice, Thanks.
I saw below debug info from maillist, from these info I guess freeradius can set VLAN for user or group.
Ready to process requests. rad_recv: Access-Request packet from host 192.168.1.1:1645, id=38, length=149 User-Name = "DOMAIN\\testuser" Service-Type = Framed-User Framed-MTU = 1500 Called-Station-Id = "00-19-AA-2C-8F-03" Calling-Station-Id = "00-08-74-46-2A-A5" EAP-Message = 0x0202001601434f5250524f4f545c7467646f72686531 Message-Authenticator = 0x9bc11b6f6182f53f6428ad12c48d8f10 NAS-Port = 50001 NAS-Port-Type = Ethernet NAS-IP-Address = 192.168.1.1 Processing the authorize section of radiusd.conf modcall: entering group authorize for request 0 rlm_eap: EAP packet type response id 2 length 22 rlm_eap: No EAP Start, assuming it's an on-going EAP conversation modcall[authorize]: module "eap" returns updated for request 0 users: Matched entry DEFAULT at line 1 modcall[authorize]: module "files" returns ok for request 0 modcall: leaving group authorize (returns updated) for request 0 rad_check_password: Found Auth-Type EAP auth: type "EAP" Processing the authenticate section of radiusd.conf modcall: entering group authenticate for request 0 rlm_eap: EAP Identity rlm_eap: processing type tls rlm_eap_tls: Initiate rlm_eap_tls: Start returned 1 modcall[authenticate]: module "eap" returns handled for request 0 modcall: leaving group authenticate (returns handled) for request 0 Sending Access-Challenge of id 38 to 192.168.1.1 port 1645 Tunnel-Type:0 = VLAN Tunnel-Medium-Type:0 = IEEE-802 Tunnel-Private-Group-Id:0 = "vlanX" EAP-Message = 0x010300061920 Message-Authenticator = 0x00000000000000000000000000000000 State = 0x67c75e29c6b4d8d32c662ce2d154d277 Finished request 0 Going to the next request --- Walking the entire request list --- Waking up in 6 seconds...
--------------------------------- �Ż��������3.5G������20M������
- List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html --------------------------------- �Ż��������3.5G������20M������