Dynamic VLAN-Assigning with Dell PowerConnect 3448

[André Graf]

Hi
That could be the solution for my problem, because I didn't find one  
installed on the system. But where can I download this dictionary? :S

Am 06.06.2007 um 08:28 schrieb Jan Schermer / ET NETERA:

> Hi,
> I was just trying to do the same thing - the device has to support  
> the VLAN settings from Radius, otherwise you are screwed :- 
> ( download the radius dictionary for powerconnect 3448 and look if  
> the parameters are in here - in my case they were not and got  
> ignored as well...
>
>
> Jan Schermer
> Linux Administrator
> ET NETERA | smart e-business solutions
> jan.schermer at etnetera.cz
> +420 608022225
> ~
> [ www.ahold.cz     |  www.annonce.cz  |  www.datart.cz ]
> [ www.knizniweb.cz |  www.siemens.cz  |  www.cz.o2.com ]
>
> Created by ET NETERA | Powered by jNetPublish
>
>
> André Graf wrote:
>> Hi List
>> Since hours i am trying to get dynamic vlan-assigning working with  
>> a Dell PowerConnect 3448 Switch and Freeradius 1.1.6. In my Users- 
>> File I have the following Default-Entry (like seen in some other  
>> tutorials, often used with Cisco-devices).
>> DEFAULT Auth-Type := EAP
>>         Tunnel-Type = 13,
>>         Tunnel-Medium-Type = 6,
>>         Tunnel-Private-Group-Id = 110
>> The authentication succeed, but I don't fall in to the defined  
>> VLAN. (I always fall in to the Switch-Default-VLAN #1)
>> Are there some kind of "special" settings with this DELL-Switch or  
>> is there an other solution for my problem?
>> Thank you for your answers!
>> Greetings
>> Andre
>> --------------------------------------------------------------------- 
>> ---
>> - List info/subscribe/unsubscribe? See http://www.freeradius.org/ 
>> list/users.html
>
> -
> List info/subscribe/unsubscribe? See http://www.freeradius.org/list/ 
> users.html