What nastype for Extreme switch?

[Mats Blomgren B]

Hi,

Not sure this answers your question but..
I use the following setup for extreme switches..

############
# Access layer
admin		NAS-IP-Address == 192.168.0.9, Auth-Type = System
		Service-Type = Administrative-User 


############

Administrative-User = Read/Write
Login-User = Read only

Best Regards
 
Mats Blomgren B

-----Original Message-----
From: freeradius-users-bounces+mats.b.blomgren=ericsson.com at lists.freeradius.org [mailto:freeradius-users-bounces+mats.b.blomgren=ericsson.com at lists.freeradius.org] On Behalf Of Wagner Pereira
Sent: den 15 april 2010 16:26
To: FreeRadius users mailing list
Subject: What nastype for Extreme switch?

Hi, all.

I installed the AAA model Radius on my Extreme's switch and I am already able to log in into it, but I just enter in this device through the non-privileged mode ( > ).

I was taking a look at http://linux.die.net/man/5/clients.conf and it says:

----------------------------
nastype
The nastype attribute is used to tell the checkrad.pl script which NAS-specific method it should use when checking simultaneous use.
The following values are currently recognized:

cisco
computone
livingston
max40xx
multitech
netserver
pathras
patton
portslave
tc
usrhiper
other
----------------------------

Which of these nastype values I must to use for Extreme devices?

Thanks.

-- 

Wagner Pereira

PoP-SP/RNP - Ponto de Presença da RNP em São Paulo CCE/USP - Centro de Computação Eletrônica da Universidade de São Paulo http://www.pop-sp.rnp.br Tel. (11) 3091-8901

-
List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html