I just access-lists and time zones. All the config is done on the cisco router. FreeRadius is only used to reference the policy map. Andrew Paternoster Senior System Engineer [http://www.gpk.net.au/signatures/logo.jpg]<http://www.gpk.net.au/> [http://www.gpk.net.au/signatures/spacer.jpg] 2/94 Abbott Road, Hallam, VIC 3083 Phone: 1300 854 223 Fax: 1300 854 228 www.gpk.net.au<http://www.gpk.net.au/> Did you know that you can now log faults by just sending an email to support@gpk.net.au<mailto:support@gpk.net.au> The information contained in or accompanying this e-mail is intended only for the use of the stated recipient and may contain information that is confidential and/or privileged. If the reader is not the intended recipient or the agent thereof, you are hereby notified that any dissemination, distribution or copying of this e-mail is strictly prohibited and may constitute a breach of confidence and/or privilege. If you have received this e-mail in error, please notify us immediately. Any views or opinions presented are those solely of the author and do not necessarily represent those of GPK Computers Pty Ltd.. Warning: Although the company has taken reasonable precautions to ensure no viruses are present in this e-mail, the company cannot accept responsibility for any loss or damage arising from the use of this e-mail or attachments From: freeradius-users-bounces+andrew=gpk.net.au@lists.freeradius.org [mailto:freeradius-users-bounces+andrew=gpk.net.au@lists.freeradius.org] On Behalf Of Ilir Nako Sent: Wednesday, 23 December 2009 8:21 PM To: FreeRadius users mailing list Subject: Re: Rate-Limit On 12/23/2009 9:57 AM, javkhlanbaatar@nimon.mn<mailto:javkhlanbaatar@nimon.mn> wrote: Hi, I have freeRadius server connected to Cisco Router as PPPoE Server (Remote Access Server). I can limit customers' bandwidth limit by using Rate-limit function. But I want to give unlimited bandwidth to some specified IPs. Also time-based (I mean at the midnight I can give no bandwidth limitation to the customers.) How can I make it in freeradius? Thanks - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html Hello I am not expert in freeradius but from an another radius system I give this attribute $Cisco-AVPair=ip:sub-policy-Out=''Policy-Map-configured-in-cisco'' .This atribute can be added to the customer or to the group of users . The policy map is configured at the cisco router .There you can define acl time based or exlude Ip from rate limiting Regards Ilir